Laminator temperature cloth

One, main characteristics:

1, laminating machine high temperature cloth used for low temperature of -196 DEG C, between the high temperature of 350 DEG C, with weather resistance, anti aging. Through practical application, such as in the 250 C

High temperature conditions placed consecutively for 200 days, not only the strength is not low, and the weight is not reduced; placed 120 hoursat 350 DEG C high temperature, weight

Only reduced by about 0.6% in the temperature of -180 DEG C; ultra low temperature can not crack, and keep the softness of the original.

2, high temperature adhesive laminator Buffay: not easy adhesion any material. Easy to clean the surface of the attachment of grease, stains orother attachment

A matter; paste, resin, coating and so on almost all the adhesive material can be easily removed;

3, laminating machine high temperature cloth chemical corrosion,corrosion ability strong acid, strong alkali, aqua regia and various organic solvents.

4, laminating machine high temperature cloth low friction coefficient(0.05-0.1), is the best choice for oil-free self-lubricating.

5, laminating machine high temperature cloth light transmission rate of 6~ 13%.

6, laminating machine high temperature cloth with high insulationproperties (dielectric constant is small: 2.6, tangent below 0.0025), anti UV, anti-static.

7, laminating machine high temperature cloth good dimensional stability(elongation factor is less than 5 per thousand), high strength. Good mechanical properties..

Two, the correct use method is:

Equipped with at least 4 pieces of laminated cloth in a laminating machine. After each use, do not immediately repeated use, but to set aside for not sticking to thoroughly check

Bottom cooling down, and then laminated cloth EVA completely clean thelaminated cloth has maintained the original color. If it can be laminated cloth on the

EVA completely clean the EVA again when in use will be glued to thebattery assembly on glass. Now EVA no matter what will be in the glasscleaning

Leave EVA particles. Panels for outdoor use, these EVA particles will remelt viscosity on the glass. And the adsorption of the dust on the glass.Some ash

Dust can be removed. Sometimes the dust will block the battery piece will be the formation of hot spot effect long.

In three, the matters needing attention:

First, in the cutting cloth laminated to the front mounted on the machine,please try to keep the smooth surface of high temperature cloth , otherwise it will cause the laminate surface creases, affect the service life!

II, in use, if the anti sticking cloth surface with EVA glue or other residuesadhesion in the above, as long as the use of semi wet cloth to wipe clean!

Thirdly, different batches of laminated cloth colors may be different, this is a normal phenomenon, but it does not affect the quality of products,but will not affect the use!